How To Put On A Motorcycle Helmet Strap? The Ultimate Guide


If you are a new or experienced rider, you have to put on a motorcycle helmet strap, which is an important thing. If loose or strapping on your face if there is an accident. The problem here, as you correctly fitted to make the helmet. So, both comfortable and safe.

Motorcycle helmet usually has two types. The first is the full face. Another, which is cheaper, is an open-face helmet. But, both have the same helmet mounting bracket connector is best.The standard helmet should have it. Otherwise, you can from your head go off in an accident. This makes the head exposed and damaged. At least transformed fall the helmet. Thus, the helmets cover only a certain part of the head.

First, to provide security, and shortly before the strapping, make sure that the helmet is standard! To put on a motorcycle helmet strap, the belt fasteners helmet must be tight and rope belt must be in good condition. Strap on helmet properly that your helmet can be done only once, is normal. Then you can follow these steps:

Let's Know How To put on a motorcycle helmet strap


Pull the helmet correctly inward

First, you need to put the helmet on the head. Lower trunk and also part of the chin. Ensure within the sponge does not close (hence it is less comfortable) or too loose (so that the helmet moves from side to side all the time). In this step, you create the outer band connector while pulling the helmet down. So keep your rope handle, so you can easily fix it later.

Put on a motorcycle helmet strap correctly

Now you can attach the rope belt directly under the chin metal ring ports at the rear. Pull the belt firmly against the base of the chin. Then pull rings, belt buckles and back on the first ring. Place the strap under the second ring and bring it to the right.

Safe and loosen the belt

You fell with Confidence! If you think that the head is out of place, tighten and loosen until it feels comfortable. In this way ensures the use of the helmet fits on the head. Sometimes when you push too much, you could hurt to take a breath. If the belt is too loose, no insurance.

To put on a motorcycle helmet strap , not a difficult process. Yet, many people have less attention to loose and usually leave bad plug-in. People often forget to do the tape or cable, are not strong enough. It is a safety factor of simple step.

If you do not simply rely on good helmets with cord strap and use it! If someone this Council has noted, then he / she was safe to travel. The next step is to ensure that the state of the ring ports.

More information about to put on a motorcycle helmet strap

  • Use once a week to prevent rust, the oil in the metal ring connections available. Normally, when a rider uses a helmet for several months, it oxidizes. It makes the strap on the helmet difficulties and delays feel. Oil can avoid gentle and oxidation.
  • It is not too tight or too loose against the helmet for strapping. If it is too tight, it is causing discomfort. It blocks to breathe the way to the neck. If it is too loose, it is dangerous.
  • To open the helmet, you should be careful about that. Above for the previous tips easily slide up and in a motorcycle accident, sudden movement finds the part of front open helmets can. So, make sure that the belt is strong enough.
  • Do not measure the top-down helmet for the empty space inside the helmet. So, we can see the use of helmets estimate a level of security.

Strap on the helmet is easy as long as the corresponding procedure known to all. If your helmet straps think the chain broke, you can put the helmet for the repair. Replace the rope belt broken by the news. The point to ensure that the first web condition. It fact, it is easy to put on a motorcycle helmet strap in a good place.


Click Here to Leave a Comment Below 0 comments
↓